Honeycomb bookstand, designed for medium-large books.
maximum book thickness 46 mm.
Maximum recommended book size is around 20×30 cm, taller books might shift the center of gravity and make the stand tip backwards
The honeycomb pattern is decorative, but .also saves around 60% material.
I printed it without support, and it came out rather nice, needing only a little cleanup.
For best result support is recommended though – but it will double the needed material from around 30 grams to over 60 grams
I printed it with 0.19 mm layers in Z-ABS – for smoother details 0.14 mm layers is recommended, but less than that most likely won’t yield a better result, only take up more time to print.
Be the First to Comment!
You must be logged in to post a comment.
You must be logged in to post a comment.
Asymetric honeycomb bookstand MG
by gertsen@gmail.comHoneycomb bookstand MG
by gertsen@gmail.comMakita LXT bits-holder for 6 bits
by gertsen@gmail.comDrill guide, 10/20/30/40 mm square
by gertsen@gmail.comAdd this project to collection
This website uses cookies to improve users experience while visiting the website. Cookies are small files stored on your computer that track, save and store information about user’s interactions and use of the website. Users are informed that they may refuse to use cookies by selecting the appropriate settings in your browser.