Vacuum Infusion Port by IanP

2
4706
0
105

Download Project

License: Creative Commons - Public Domain Dedication

Printed on
Zortrax M200
Used materials
HIPS
Designed in
Inventor
Tags
Carbon FibreCompositeLRTMPortport & NutRTMVacuum Infusion

IanP Australia

Contact Me

About

User hasn't filled out personal information.

More by IanP

Show all projects from IanP

Through bag Vacuum Infusion Port to fit 13mm hose
This port is designed to be used in vacuum bagging composite parts.
I use these ports in Vacuum Resin Infusion of Carbon Fibre.
They can be used in wet lay vacuum bagging as well as resin Infusion.
These port are re-usable.

I punch a 22.4mm (7/8") hole in my vacuum bag where I require the port to be located then I use a silicone disk (55mm with a 23mm hole) as a gasket between the bag and the lower part of the port and past the port through the hole and fasten the nut on the outside of the bag.
I tighten lightly with 27mm and 17mm spanners and attach my plumbing. I use 13mm low density irrigation poly pipe.
I rease wax the lower part of the port to make it easy to clean the resin off and I drill the dried resin out through the centre to reuse.