Zortrax M200 ABS spool holder v4
by Zortrax 31 August 2015 in Zortrax Parts
Report abuse
by Zortrax 31 August 2015 in Zortrax Parts
Use this part to hold filament spool at the back of your printer.
Use Z-ABS to get best resoults.
All default settings are recommended.
| Last Update | Type | Downloads | Size | |||
|---|---|---|---|---|---|---|
|
Zortrax-M200-ABS-spool-holder-v4.zproj | 31 August 2015 |
.zproj | 859 | 425,21 KB | |
3 Comments
You must be logged in to post a comment.
You must be logged in to post a comment.
My original one broke during first assembly… And no wonder it broke…
Measured values: gap = 2.65mm; metal thickness 3.58mm;
I hope this one has correct measurements.
A better solution with less stress would be a rotational interlock.
And did it have improved measurements?
Mine broke because of the weak layer bonding. Would recommend printing it on its side even if it might affect the quality. A spool dropping during a print is a bad bad thing.
Zortrax headphones
by ZortraxZortrax Inkspire FEP Film Replacement Jig
by ZortraxM200 Plus/ M300 Plus Z-FLEX Spool Holder
by ZortraxZortrax M200 Plus and M300 Plus lower fan shrouds
by ZortraxHappy Halloween Pot
by ZortraxOffice Building Architectural Mock-up
by ZortraxAdd this project to collection
We use cookies and process your personal data in compliance with the General Data Protection Regulation coming into force on May 25, 2018. Accept our Privacy and Cookies Policy if you agree to processing your personal data.