Zortrax Voronoi Heels
by Zortrax 4 September 2015 in Fashion & Accessories
Report abuse
by Zortrax 4 September 2015 in Fashion & Accessories
Voronoi heels? Why not?!
Printed on Zortrax M200 3D Printer.
Filament:
Sky Blue Z-ABS
Printing Parameters:
Layer Height: 0,14mm
Infill: Full
Support: 30°
| Last Update | Type | Downloads | Size | |||
|---|---|---|---|---|---|---|
|
|
Zortrax_Voronoi_Heel_Left.stl | 04 September 2015 |
.stl | 424 | 8,24 MB | |
|
|
Zortrax_Voronoi_Heel_Right.stl | 04 September 2015 |
.stl | 428 | 8,24 MB | |
3 Comments
You must be logged in to post a comment.
You must be logged in to post a comment.
I tried to print this shoe on 50% scale – on Zortrax M200, ABS, layer height 0,09 mm – bu there are to much support – it is hard to clean this model :/
Does the setting works for you? I set support to be 30 degree, and end up with a lot of support structure in the toe and holes.
Who made a success print on this?
what size are they?? Are they 36 37 38 39??
Resin Tank Cover
by ZortraxMedical visors
by ZortraxM300 Plus Maintenance jigs
by ZortraxSpool holders for Inventure 3D Printer
by ZortraxZortrax headphones
by ZortraxZortrax Inkspire FEP Film Replacement Jig
by ZortraxAdd this project to collection
We use cookies and process your personal data in compliance with the General Data Protection Regulation coming into force on May 25, 2018. Accept our Privacy and Cookies Policy if you agree to processing your personal data.