Drill guide, 10/20/30/40 mm square
by Gertsen 26 September 2015 in Engineering
Report abuse
by Gertsen 26 September 2015 in Engineering
A simple drill guide, for drilling a 2mm hole either 10, 20, 30 or 40 mm from two sides.
Note: It’s the distance from the sides – not the diagonal distance from the cornor.
The guide is designed to be printed upright without any support (Set support to 0 degrees.)
| Last Update | Type | Downloads | Size | |||
|---|---|---|---|---|---|---|
|
|
Drill_guide_10_20_30_40mm.stl | 26 September 2015 |
.stl | 16 | 227,91 KB | |
Be the First to Comment!
You must be logged in to post a comment.
You must be logged in to post a comment.
Asymetric honeycomb bookstand MG
by GertsenHoneycomb bookstand MG
by GertsenMakita LXT bits-holder for 6 bits
by GertsenDrill guide, 10/20/30/40 mm square
by GertsenAdd this project to collection