by Gertsen 4 October 2015 in Household Objects
Honeycomb bookstand, designed for medium-large books.
maximum book thickness 46 mm.
Maximum recommended book size is around 20×30 cm, taller books might shift the center of gravity and make the stand tip backwards
The honeycomb pattern is decorative, but .also saves around 60% material.
I printed it without support, and it came out rather nice, needing only a little cleanup.
For best result support is recommended though – but it will double the needed material from around 30 grams to over 60 grams 
I printed it with 0.19 mm layers in Z-ABS – for smoother details 0.14 mm layers is recommended, but less than that most likely won’t yield a better result, only take up more time to print.
| Last Update | Type | Downloads | Size | |||
|---|---|---|---|---|---|---|
|
|
bookstand_v3.stl | 04 October 2015 |
.stl | 55 | 156,43 KB | |
Cookies on our websites are used to improve your experience and make it more personal. Click "Accept & close" to agree to use of cookies. You can always change your privacy settings in Cookie Preferences. Read our Cookie Policy for more details.
Be the First to Comment!
You must be logged in to post a comment.
You must be logged in to post a comment.
Asymetric honeycomb bookstand MG
by GertsenHoneycomb bookstand MG
by GertsenMakita LXT bits-holder for 6 bits
by GertsenDrill guide, 10/20/30/40 mm square
by GertsenAdd this project to collection