Report abuse
The spirograph by Nixa is an interesting project which allows make the creation of regular form by using a pen or pencil. It provides a large fun with combining colors and forms and using two different sizes of circles. You can create amazing, freehand , professional graphics with this spirograph. Try to do it today !
Model was printed with following parameters:
-Material: Z-ABS
-Layer: 0.19mm
-Infill: LIGHT
-Support: none
| Last Update | Type | Downloads | Size | |||
|---|---|---|---|---|---|---|
|
|
Body.stl | 09 May 2016 |
.stl | 708 | 269,03 KB | |
|
|
Case.stl | 09 May 2016 |
.stl | 707 | 92,56 KB | |
|
|
Gear1.stl | 09 May 2016 |
.stl | 701 | 121,76 KB | |
|
|
Gear2.stl | 09 May 2016 |
.stl | 699 | 113,95 KB | |
|
|
hub.stl | 09 May 2016 |
.stl | 703 | 51,25 KB | |
1 Comment
You must be logged in to post a comment.
You must be logged in to post a comment.
Successfully printed on my M200 V4 using Z-ULTRAT Ivory using this settings:
LayerThickness:0.19 | Quality:Hi | Seam:Normal | Infill:Hi | Support:20° | Offsets:No | SBridges:No | LayersTop/Bottom:5/3 | Fan:80%
Result was really good, got no burn marks (but always had some if thickness was set at 0.15 or 0.09mm :o( ).
Rework: Just one cog of each part was very slightly too thick, because it was the starting point of each next layer and the Filament tends to be +0.1…0.2mm thicker there (maybe just a temperature issue on my side).
Mini Drill Stand By NIXA
by NIXASuperhero Book Holder By NIXA
by NIXARaspberry PI 3 Case By NIXA
by NIXASmiling Earpods Organizer By NIXA
by NIXAPS4 Controller Stand By NIXA
by NIXAClock By NIXA
by NIXAAdd this project to collection