Zortrax M200 spoolholder-wide ( V 2.5 and V 3 were prepared according to the shape of the spool.)
by adwecs 18 March 2016 in Zortrax Parts
Report abuse
by adwecs 18 March 2016 in Zortrax Parts
It has been widening in accordance with the filament spool diameter.(V2)
To allow a little wide spool , I ‘ve added what was 5mm extension .(V2.5)
To stabilize a dedicated spool , I gave a little slope toward the center of the holder top surface .
In order to adapt to the third new spool, I changed R on the top surface small.(V3)
| Last Update | Type | Downloads | Size | |||
|---|---|---|---|---|---|---|
|
SPholder-V2.stl | 18 March 2016 |
.stl | 603 | 250,18 KB | |
|
|
SPholder-V2.5.stl | 28 June 2016 |
.stl | 398 | 448,32 KB | |
|
|
SPholder-V3.stl | 28 June 2017 |
.stl | 170 | 439,54 KB | |
2 Comments
You must be logged in to post a comment.
You must be logged in to post a comment.
Printed v2.5 at 45 degree angle. So far the best spool holder.
Thank you for the compliment !
M200 Plus PF_connector guard
by adwecsNew M300 spool holder for M200spool
by adwecsCover for spool holder hole
by adwecsLeft side spool holder
by adwecsParts for Zortrax stopper
by adwecsSpool entangling detector
by adwecsAdd this project to collection