Cable holder & guide

by Hiroyuki Sakano 3 December 2015 in Zortrax Parts

Report abuse

  • 21

  • 8996

  • 0

  • 797

License: Creative Commons - Public Domain Dedication

These parts was designed so as not to put an extra load on the cable.
First, open a hole in the three cable catch accessory, and then secure it bolted. And, by, for example, sandwiching the rubber to catch the bottom, please try to use to lift as much as possible the back of the cable of the printer. The aim is that the cable is to draw an arc with a margin in the upper space of the printer. Cable guide is used to refer to the catch on the top.

Be the First to Comment!


wpDiscuz
filler
 
21

filler

by Hiroyuki Sakano
 
 
Views 7111
 
 
Comments 5
 
 
Downloads 1137
 
Cable holder & guide
 
21

Cable holder & guide

by Hiroyuki Sakano
 
 
Views 8996
 
 
Comments 0
 
 
Downloads 797