Headphone stand

by Stafford 1 February 2020 in Household Objects

Report abuse

  • 3

  • 1477

  • 0

  • 136

License: Creative Commons - Attribution

Firstly I need to acknowledge George Noyce [https://www.thingiverse.com/NoycePrints/about]. I’ve really just reworked what he started and made it my own.

This is a stand for my headphones [Sennheiser HD 4.50 BT] and it is just tall enough to carry them with the earmuffs retracted. I think that one may be able to make the sides a bit longer on the M200, but not much. I’ve not tried yet but I’m sure if you print the sides one at a time and turn them diagonally, you could make longer ones.

There are images included of how I set up each print and I’m sure you could do it a lot more economically but I did not do this as I was testing each part as I printed them.

I printed most of the parts in grey ABS. The countersink washers and feet were done using green Z-ULTRAT as this is what I had at the time.

All posts were printed using 0.09mm layer height and a 40% square infill. I set the support angle to 30 degrees.

I also used 3 off o-rings [6mm ID and 10mm OD] which I glued into the bottom of the feet to stop the stand from sliding around my desk.

The appropriate holes need to be cleared out with a 2.5mm drill and tapped M3. I did not get the hole offsets quite right so each hole needed a 2.5mm clearing drill but I’m sure you could rid of this if you got the hole offset setting correct.

The whole assembly uses M3x12 countersink Allen head screw. Be careful when tightening these as the threads are not the strongest around!

Be the First to Comment!


wpDiscuz
Chess Pieces and Board
 
0

Chess Pieces and Board

by Stafford
 
 
Views 497
 
 
Comments 0
 
 
Downloads 74
 
Headphone stand
 
3

Headphone stand

by Stafford
 
 
Views 1477
 
 
Comments 0
 
 
Downloads 136
 
Soap Saver
 
0

Soap Saver

by Stafford
 
 
Views 1107
 
 
Comments 0
 
 
Downloads 16
 
Soap dish
 
6

Soap dish

by Stafford
 
 
Views 1553
 
 
Comments 0
 
 
Downloads 63
 
Vase
 
17

Vase

by Stafford
 
 
Views 3375
 
 
Comments 1
 
 
Downloads 694
 

We use cookies and process your personal data in compliance with the General Data Protection Regulation coming into force on May 25, 2018. Accept our Privacy and Cookies Policy if you agree to processing your personal data.

X