M200/M300 Plus PTFE Tube Holder for Filament Run Out Sensor

Hi,

After printing predominately in ABS I’ve switched over to printing a lot in PETG and with moisture being a problem I’ve put everything in a sealed box. I was going to use my original spool holder I made but means I would need to drill another hole for cables to run for the filament sensor. I’ve decided to just use my spool holder as a holder without the sensor and reconnect the factory sensor. Problem is you can’t get anything to hold the tube in place. I’ve basically sliced my old model to just get the mount for holding the PTFE tube in place.

Enjoy